Users Guide

Policy-based Routing (PBR)

Policy-based routing (PBR) allows a switch to make routing decisions based on policies applied to an

interface.

Overview

When a router receives a packet, the router decides where to forward the packet based on the destination

address in the packet, which is used to look up an entry in a routing table. However, in some cases, there may

be a need to forward the packet based on other criteria: size, source, protocol type, destination, and so on.

For example, a network administrator might want to forward a packet that uses transmission control protocol

(TCP) across a different next-hop than packets using Internet control message protocol (ICMP). In these

situations, you can a configure switch route packet according to a policy applied to interfaces.

In another scenario, when the packet comes from one source and wants to go to another destination, then

route it to this next-hop or onto that specific interface. This permits routing over different links or towards

different networks even while the destination is the same but depending on where the packet originates.

Policy-based Routing (PBR) 672