Users Guide

Viewing the LLDP Configuration
To view the LLDP configuration, use the following command.
• Display the LLDP configuration.
CONFIGURATION or INTERFACE mode
show config
Examples of Viewing LLDP Configurations
The following example shows viewing an LLDP global configuration.
Dell(conf)#protocol lldp
Dell(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 10
no disable
Dell(conf-lldp)#
Dell(conf-lldp)#exit
Dell(conf)#interface gigabitethernet 1/31
Dell(conf-if-gi-1/31)#show config
!
interface GigabitEthernet 1/31
no ip address
switchport
no shutdown
Dell(conf-if-gi-1/31)#protocol lldp
Dell(conf-if-gi-1/31-lldp)#show config
!
protocol lldp
Dell(conf-if-gi-1/31-lldp)#
Viewing Information Advertised by
Adjacent LLDP Agents
To view brief information about adjacent devices or to view all the information that neighbors are advertising,
use the following commands.
• Display brief information about adjacent devices.
show lldp neighbors
• Display all of the information that neighbors are advertising.
show lldp neighbors detail
Link Layer Discovery Protocol (LLDP) 546