Users Guide

• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Distribute Routes
Another method of controlling routing information is to filter the information through a prefix list.
Prefix lists are applied to incoming or outgoing routes and routes must meet the conditions of the prefix lists
or Dell Networking OS does not install the route in the routing table. The prefix lists are globally applied on all
interfaces running IS-IS.
Configure the prefix list in PREFIX LIST mode prior to assigning it to the IS-IS process. For configuration
information on prefix lists, refer to Access Control Lists (ACLs).
Applying IPv4 Routes
To apply prefix lists to incoming or outgoing IPv4 routes, use the following commands.
NOTE
: These commands apply to IPv4 IS-IS only. To apply prefix lists to IPv6 routes, use ADDRESS-
FAMILY IPV6 mode, shown later.
• Apply a configured prefix list to all incoming IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name in [interface]
Enter the type of interface and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• Apply a configured prefix list to all outgoing IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name out [bgp as-number | connected | ospf process-
id | rip | static]
You can configure one of the optional parameters:
• connected: for directly connected routes.
• ospf process-id: for OSPF routes only.
• rip: for RIP routes only.
• static: for user-configured routes.
Intermediate System to Intermediate System 489