Users Guide

CONFIGURATION mode
interface interface-type
5 Set the local port speed.
INTERFACE mode
speed {10 | 100 | 1000 | 10000 | auto}
NOTE: If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10 Gigabit SFP
+ port or 1 Gigabit SFP port. You can use the speed command to enable the required speed.
6 Optionally, set duplex.
INTERFACE mode
duplex full
7 Disable auto-negotiation on the port.
INTERFACE mode
no negotiation auto
If the speed was set to 1000, do not disable auto-negotiation.
8 Verify configuration changes.
INTERFACE mode
show config
Example of the show interfaces status Command to View Link Status
NOTE: The show interfaces status command displays link status, but not administrative status. For
both link and administrative status, use the show ip interface command.
Dell#show interfaces status
Port Description Status Speed Duplex Vlan
Gi 1/1 Down Auto Auto --
Gi 1/2 Down Auto Auto --
Gi 1/3 Down Auto Auto --
Gi 1/4 Down Auto Auto --
Gi 1/5 Down Auto Auto --
Gi 1/6 Down Auto Auto --
Gi 1/7 Down Auto Auto --
Gi 1/8 Down Auto Auto --
Gi 1/9 Down Auto Auto --
Gi 1/10 Down Auto Auto --
Gi 1/11 Down Auto Auto --
Gi 1/12 Down Auto Auto --
Gi 1/13 Down Auto Auto --
Gi 1/14 Down Auto Auto --
Gi 1/15 Down Auto Auto --
Gi 1/16 Down Auto Auto --
Gi 1/17 Down Auto Auto --
Gi 1/18 Down Auto Auto --
Gi 1/19 Down Auto Auto --
Gi 1/20 Down Auto Auto --
Gi 1/21 Down Auto Auto --
Gi 1/22 Down Auto Auto --
Gi 1/23 Down Auto Auto --
Gi 1/24 Down Auto Auto --
Te 1/25 Down Auto Auto --
Interfaces 409