Users Guide

NOTE: Non-existing interfaces are excluded from the interface range prompt.

NOTE: When creating an interface range, interfaces appear in the order they were entered and are not

sorted.

The show range command is available under Interface Range mode. This command allows you to display all

interfaces that have been validated under the interface range context.

The show configuration command is also available under Interface Range mode. This command allows

you to display the running configuration only for interfaces that are part of interface range.

You can avoid specifying spaces between the range of interfaces, separated by commas, that you configure

by using the interface range command. For example, if you enter a list of interface ranges, such as

interface range te 50/1,gi 3/9, this configuration is considered valid. The comma-separated list is

not required to be separated by spaces in between the ranges. You can associate multicast MAC or hardware

addresses to an interface range and VLANs by using the

mac-address-table static multicast-mac-

address vlan vlan-id output-range interface command.

Bulk Configuration Examples

Use the interface range command for bulk configuration.

• Create a Single-Range

• Create a Multiple-Range

• Exclude Duplicate Entries

• Exclude a Smaller Port Range

• Overlap Port Ranges

• Commas

• Add Ranges

Create a Single-Range

The following is an example of a single range.

Example of the interface range Command (Single Range)

Dell(config)# interface range gigabitethernet 1/1 - 1/23

Dell(config-if-range-gi-1/1-1/23)# no shutdown

Dell(config-if-range-gi-1/1-1/23)#

Create a Multiple-Range

The following is an example of multiple range.

Example of the interface range Command (Multiple Ranges)

Dell(conf)#interface range gigabitethernet 1/5 - 1/10 , gigabitethernet 1/1 , vlan

Dell(conf-if-range-gi-1/1,gi-1/5-1/10,vl-1)#

Interfaces 398