Users Guide

hash-algorithm seed {seed value}
• Change to another algorithm.
CONFIGURATION mode
hash-algorithm [ecmp{crc16|crc16cc|crc32LSB|crc32MSB|crc-upper|dest-ip|lsb|xor1|
xor2|xor4|xor8|xor16}]
Example of the hash-algorithm Command
Dell(conf)#hash-algorithm ecmp xor 26 lag crc 26 nh-ecmp checksum 26
Dell(conf)#
The hash-algorithm command is specific to ECMP group. The default ECMP hash configuration is crc-
lower. This command takes the lower 32 bits of the hash key to compute the egress port. Other options for
ECMP hash-algorithms are:
• crc16 — uses 16 bit CRC16-bisync polynomial
• crc16cc — uses 16 bit CRC16 using CRC16-CCITT polynomial
• crc32LSB — uses LSB 16 bits of computed CRC32
• crc32MSB — uses MSB 16 bits of computed CRC32(default)
• crc-upper — uses the upper 32 bits of the hash key to compute the egress port.
• dest-ip — uses destination IP address as part of the hash key.
• lsb — uses the least significant bit of the hash key to compute the egress port.
• xor1 — uses Upper 8 bits of CRC16-BISYNC and lower 8 bits of xor1
• xor2 — Upper 8 bits of CRC16-BISYNC and lower 8 bits of xor2
• xor4 —Upper 8 bits of CRC16-BISYNC and lower 8 bits of xor4
• xor8 — Upper 8 bits of CRC16-BISYNC and lower 8 bits of xor8
• xor16 — uses 16 bit XOR.
Bulk Configuration
Bulk configuration allows you to determine if interfaces are present for physical interfaces or configured for
logical interfaces.
Interface Range
An interface range is a set of interfaces to which other commands may be applied and may be created if there
is at least one valid interface within the range.
Bulk configuration excludes from configuration any non-existing interfaces from an interface range. A default
VLAN may be configured only if the interface range being configured consists of only VLAN ports.
The interface range command allows you to create an interface range allowing other commands to be
applied to that range of interfaces.
The interface range prompt offers the interface (with slot and port information) for valid interfaces. The
maximum size of an interface range prompt is 32. If the prompt size exceeds this maximum, it displays (...) at
the end of the output.
Interfaces 397