Users Guide

Example of the garp timer Command
Dell(conf)#garp timer leav 1000
Dell(conf)#garp timers leave-all 5000
Dell(conf)#garp timer join 300
Verification:
Dell(conf)#do show garp timer
GARP Timers Value (milliseconds)
----------------------------------------
Join Timer 300
Leave Timer 1000
LeaveAll Timer 5000
Dell(conf)#
Dell Networking OS displays this message if an attempt is made to configure an invalid GARP timer:
Dell(conf)#garp timers join 300 % Error: Leave timer should be >= 3*Join timer.
RPM Redundancy
The current version of Dell Networking OS supports 1+1 hitless route processor module (RPM) redundancy.
The primary RPM performs all routing, switching, and control operations while the standby RPM monitors the
primary RPM. In the event that the primary RPM fails, the standby RPM can assume control of the system
without requiring a chassis reboot.
This section contains the following sub-sections:
• Automatic and Manual RPM Failover
• RPM Synchronization
GARP VLAN Registration Protocol (GVRP) 340