Users Guide

neighbor {ip-address | peer-group-name} weight weight
• weight: the range is from 0 to 65535.
The default is 0.
• Sets weight for the route.
CONFIG-ROUTE-MAP mode
set weight weight
• weight: the range is from 0 to 65535.
To view BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode or the
show running-config bgp command in EXEC Privilege mode.
Enabling Multipath
By default, the software allows one path to a destination. You can enable multipath to allow up to 64 parallel
paths to a destination.
NOTE
: Dell Networking recommends not using multipath and add path simultaneously in a route
reflector.
To allow more than one path, use the following command.
The show ip bgp network command includes multipath information for that network.
• Enable multiple parallel paths.
CONFIG-ROUTER-BGP mode
maximum-paths {ebgp | ibgp} number
Filtering BGP Routes
Filtering routes allows you to implement BGP policies.
You can use either IP prefix lists, route maps, AS-PATH ACLs or IP community lists (using a route map) to
control which routes the BGP neighbor or peer group accepts and advertises. Prefix lists filter routes based on
route and prefix length, while AS-Path ACLs filter routes based on the ASN. Route maps can filter and set
conditions, change attributes, and assign update policies.
NOTE
: Dell Networking OS supports up to 255 characters in a set community statement inside a route
map.
NOTE: You can create inbound and outbound policies. Each of the commands used for filtering has in
and out parameters that you must apply. In Dell Networking OS, the order of preference varies
depending on whether the attributes are applied for inbound updates or outbound updates.
For inbound and outbound updates the order of preference is:
• prefix lists (using the neighbor distribute-list command)
• AS-PATH ACLs (using the neighbor filter-list command)
• route maps (using the neighbor route-map command)
Prior to filtering BGP routes, create the prefix list, AS-PATH ACL, or route map.
Border Gateway Protocol IPv4 (BGPv4) 247