Users Guide

Consider an example VRRP for IPv6 configuration in which the IPv6 VRRP group consists of two routers.
Figure 141. VRRP for IPv6 Topology
NOTE: This example does not contain comprehensive directions and is intended to provide guidance for
only a typical VRRP configuration. You can copy and paste from the example to your CLI. Be sure you
make the necessary changes to support your own IP addresses, interfaces, names, and so on.
NOTE: In a VRRP or VRRPv3 group, if two routers come up with the same priority and another router
already has MASTER status, the router with master status continues to be master even if one of two
routers has a higher IP or IPv6 address.
Router 2
R2(conf)#interface gigabitethernet 1/1
R2(conf-if-gi-1/1)#no ip address
Virtual Router Redundancy Protocol (VRRP) 1134