Install Guide

Console Port RJ-45 to
RJ-45
Rollover
Cable
RJ-45 to
RJ-45
Rollover
Cable
RJ-45 to
DB-9 Adapter
Terminal
Server Device
Signal RJ-45 Pinout RJ–45 Pinout DB-9 Pin Signal
RxD 6 3 3 TxD
NC 7 2 4 DTR
CTS 8 1 7 RTS
Default Configuration
A version of Dell Networking OS is pre-loaded on the system; however, the
system is not configured when you power up for the first time (except for the
default host name, which is Dell).
You must configure the system using the CLI.
Configuring Layer 2 (Data Link) Mode
To enable Layer 2 data transmissions through an individual interface, use the
switchport command in INTERFACE mode.
You cannot configure switching or Layer 2 protocols such as spanning tree
protocol (STP) on an interface unless the interface has been set to Layer 2
mode.
1. Enable the interface.
INTERFACE mode
no shutdown
2. Place the interface in Layer 2 (switching) mode.
INTERFACE mode
switchport
To view the interfaces in Layer 2 mode, use the show interfaces
switchport
command in EXEC mode.
Installing the Software
19