CLI Guide

To return to the default values, use the no is-type command.
Parameters
level-1 Allows a router to act as a Level 1 router.
level-1-2 Allows a router to act as both a Level 1 and Level 2 router.
This setting is the default.
level-2-only Allows a router to act as a Level 2 router.
Defaults level-1-2
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information
The IS-IS protocol automatically determines area boundaries and are able to keep
Level 1 and Level 2 routing separate. Poorly planned use of this feature may cause
configuration errors, such as accidental area partitioning.
If you are configuring only one area in your network, you do not need to run both
Level 1 and Level 2 routing algorithms. You can configure the IS type as Level 1.
log-adjacency-changes
Generate a log messages for adjacency state changes.
Syntax
log-adjacency-changes
To disable this function, use the no log-adjacency-changes command.
Defaults Adjacency changes are not logged.
992
Intermediate System to Intermediate System (IS-IS)