CLI Guide

dot1p vlan-
priority-value
Enter the dot1p value of the VLAN priority tag assigned to
the incoming packets in an iSCSI session. The range is from
0 to 7. The default is the dot1p value in ingress iSCSI frames
is not changed and is the same priority is used in iSCSI TLV
advertisements if you did not enter the iscsi priority-
bits command.
dscp dscp-value Enter the DSCP value assigned to the incoming packets in
an iSCSI session. The valid range is from 0 to 63. The default
is: the DSCP value in ingress packets is not changed.
remark Marks the incoming iSCSI packets with the configured dot1p
or DSCP value when they egress to the switch. The default
is: the dot1and DSCP values in egress packets are not
changed.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage Information By default, iSCSI flows are assigned to dot1p priority 4.
iscsi enable
Globally enable iSCSI optimization.
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization
feature.
Defaults Disabled.
Command Modes CONFIGURATION
iSCSI Optimization
945