CLI Guide

iscsi aging time
Set the aging time for iSCSI sessions.
Syntax
iscsi aging time time
To remove the iSCSI session aging time, use the no iscsi aging time
command.
Parameters
time Enter the aging time for the iSCSI session. The range is from
5 to 43,200 minutes.
Defaults 10 minutes
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
iscsi cos
Set the QoS policy that is applied to the iSCSI flows.
Syntax
iscsi cos {enable | disable | dot1p vlan-priority-value
[remark] | dscp dscp-value [remark]}
To disable the QoS policy, use the no iscsi cos command.
Parameters
enable Enter the keyword enable to allow the application of
preferential QoS treatment to iSCSI traffic so that the iSCSI
packets are scheduled in the switch with a dot1p priority 4
regardless of the VLAN priority tag in the packet. The default
is: the iSCSI packets are handled with dotp1 priority 4
without remark.
disable Enter the keyword disable to disable the application of
preferential QoS treatment to iSCSI frames.
944
iSCSI Optimization