CLI Guide

infinite Enter the keyword infinite to specify that the RDNSS
lifetime does not expire.
Defaults Not Configured
Command Modes INTERFACE CONFIG
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.0) Introduced on the Z9000, S6000, S4810, S4820T, and MXL..
Usage Information Use this command to add, edit, or delete an IPv6 RDNSS address and lifetime value.
You can configure up to four IPv6 RDNSS addresses. You must specify a lifetime
using the lifetime or infinite parameter.
Example
Dell(conf-if-gi-1/1)# ipv6 nd dns-server 1000::1 1
ipv6 nd prefix
Specify which IPv6 prefixes are included in Neighbor Advertisements.
Syntax
ipv6 nd prefix {ipv6-prefix | prefix-length | default} [no-
advertise] | [no-autoconfig] [no-rtr-address] [off-link]
[lifetime {valid | infinite} {preferred | infinite}]
Parameters
ipv6-prefix Enter an IPv6 prefix.
prefix-length Enter the prefix then the prefix length. The length range is
from 0 to 128.
default Enter the keyword default to set default parameters for all
prefixes.
no-advertise Enter the keyword no-advertise to prevent the specified
prefix from being advertised.
no-autoconfig Enter the keywords no-autoconfig to disable Stateless
Address Autoconfiguration.
IPv6 Basics
925