CLI Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
Syntax
ipv6 access-list access-list-name cpu-qos
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-name Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control
plane traffic only (CoPP).
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition.
ospfv3 Specify that this ACL is for OSPFv3 control plane traffic
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet
is dropped.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
908
IPv6 Access Control Lists (IPv6 ACLs)