CLI Guide

Version Description
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
This command provides egress port information for a given IP flow. This
information is useful in identifying which interface the packet follows in the case of
Port-channel and Equal Cost Multi Paths. Use this command for routed packed
only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information
when load-balance mac hashing is also configured due to insufficient
information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP
route table.
Example
Dell# show ip flow interface Gi 2/42 20.1.1.1 100.1.1.2
protocol tcp
Flow: 20.1.1.1 100.1.1.2 6
Ingress interface: Gi 2/42
Egress Interface: Gi 2/43
Dell#
show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL)
Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
882
IPv4 Routing