CLI Guide

Field Description
• ex — the entry expired.
• ?? — the entry is suspect.
TTL Displays the amount of time until the entry ages out of the
cache. For dynamically learned entries only.
Type Displays IP as the type of entry.
Address Displays the IP addresses assigned to the host.
Example
Dell# show hosts
Default domain is not set
Name/address lookup uses static mappings
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
Dell#
Related
Commands
• traceroute — view the DNS resolution.
• ip host — configure a host.
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {stack-unit-number} [port-set {pipe-number} | vrf
vrf-name {ip-address mask [longer-prefixes [ecmp-group detail]]}| ecmp-
group {detail | member-info [detail [group-index index-number]]}|
summary]
Parameters
stack-unit-
number
Enter the stack-unit ID. The unit ID range is from 1 to 6.
port-set pipe-
number
Enter the keyword port-set then the number of the stack unit’s port-
pipe. The unit ID range is from 0 to 0.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display CAM
entries corresponding to that VRF.
network mask
[longer-prefixes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for
that route only. You can enter one of the following keywords to filter
results.
876
IPv4 Routing