CLI Guide

source-dest-
mac ]
• dest-module-id — Use dest-module-id field in hash
calculation.
• vlan — Use vlan field in hash calculation .
• ethertype — Use Ethertype field in hash calculation.
• source-dest-mac — Use SMAC and DMAC fields in hash
calculation.
tunnel [ipv4-over-
ipv4 | ipv4-over-
gre-ipv4 | mac-
in-mac]}
To use tunnel key fields in hash computation, enter the
keyword tunnel then one of the parameters:
• ipv4-over-ipv4 — Use ipv4-over-ipv4 field in hash
calculation.
• ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 field in
hash calculation.
• mac-in-mac — Use mac-in-mac field in hash
calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-
port).
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
868
IPv4 Routing