CLI Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Introduced for the E-Series.
Usage Information This command disables the incrementing of the hops field when boot requests are
relayed to a DHCP server through Dell Networking OS. If the incoming boot
request already has a non-zero hops field, the message is relayed with the same
value for hops. However, the message is discarded if the hops field exceeds 16, to
comply with the relay agent behavior specified in RFC 1542.
Related
Commands
• ip helper-address — specify the destination broadcast or host address for DHCP
server requests.
• show running-config — display the current configuration and changes from the
default values.
ip host
Assign a name and an IP address to the host-to-IP address mapping table.
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped
to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
850
IPv4 Routing