CLI Guide

To view current bindings, use the show hosts command.
Related
Commands
• ip domain-list — configure additional names.
ip helper-address
Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the
DHCP server is not on the same subnet as the client.
Syntax
ip helper-address ip-address
To remove a DHCP server address, use the no ip helper-address command.
Parameters
ip-address Enter an IP address in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
848
IPv4 Routing