CLI Guide

Parameters
name Enter a domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information To configure a list of possible domain names, configure the ip domain-list
command up to six times.
If you configure both the ip domain-name and ip domain-list commands,
the software tries to resolve the name using the
ip domain-name command. If
the name is not resolved, the software goes through the list of names configured
with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the show running-config resolve command.
Related
Commands
• ip domain-name — specify a DNS server.
IPv4 Routing
845