CLI Guide

debug ip packet
View a log of IP packets sent and received.
Syntax
debug ip packet [access-group name] [count value] [interface]
To disable debugging, use the no debug ip packet [access-group name]
[count value] [interface] command.
Parameters
access-group
name
Enter the keyword access-group then the access list
name (maximum 16 characters) to limit the debug output
based on the defined rules in the ACL.
count value (OPTIONAL) Enter the keyword count then the count value.
The range is from 1 to 65534. The default is Infinity.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
840
IPv4 Routing