CLI Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Usage Information In Dell Networking OS versions prior to 8.3.1.0, if a gratuitous ARP is received some
time after an ARP request is sent, only RP2 installs the ARP information. For
example:
1. At time t=0, Dell Networking OS sends an ARP request for IP A.B.C.D.
2. At time t=1, Dell Networking OS receives an ARP request for IP A.B.C.D.
3. At time t=2, Dell Networking OS installs an ARP entry for A.B.C.D only on RP2.
Beginning with Dell Networking OS version 8.3.1.0, when a gratuitous ARP is
received, Dell Networking OS installs an ARP entry on all three CPUs.
arp max-entries
Enables you to configure the maximum number of ARP entries per VRF that are allowed for IPv4..
Syntax
arp max-entries [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the name of a specific VRF for which you want to
configure maximum number of ARP entries that IPv4 allows.
max-number Enter the maximum number of ARP entries that a VRF RTM
can hold. The range is from 0 to 65535.
Defaults Not configured.
Command Modes CONFIGURATION
IPv4 Routing
827