CLI Guide

all Configure all applications.

Defaults None.

Command Modes EIS Mode (conf-mgmt-eis)

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.2(1.0) Introduced on the Z9500.

9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.

application (for HTTP and ICMP)

Configure the management egress interface selection for HTTP and ICMP.

NOTE: Only the options that have been newly introduced are described here. For a complete

description on all of the keywords and variables that are available with this command, refer the

respective Command Reference Guide of the applicable platform of the Release 9.2(0.0)

documentation set.

Syntax

application {all | application-type}

To remove a management application configuration, use the no application

{all | application-type} command.

Parameters

application-type Enter any of the following keywords:

• For HTTP, enter the keyword http.

• For ICMP, enter the keyword icmp.