CLI Guide

show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface-type
Parameters
interface Enter one of the following keywords and the interface
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For stack-units, enter the keywords stack-unit then
the slot/port information.
• For a Null interface, enter the keyword null then the
Null interface number.
• For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the tunnel interface type.
9.1(0.0) Updated Management Ethernet output to include two
global IPv6 addresses on S4810 and Z9000 and added
output example showing OpenFlow instance ID.
Interfaces
759