CLI Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an
IP address or switchport. To place an interface in Layer 2 mode, ensure that the
interface’s configuration does not contain an IP address and enter the switchport
command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface
with no default configuration. To delete a tunnel interface, use the no interface
tunnel tunnel-id command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)# int tengigabitethernet 1/10
Dell(conf-if-gi-1/10)# exit
Dell(conf)#
Related
Commands
• interface loopback — configure a Loopback interface.
• interface null — configure a Null interface.
• interface port-channel — configure a port channel.
• interface vlan — configure a VLAN.
• show interfaces — display the interface configuration.
interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set
of configurations on a group of interfaces.
Syntax
interface group [interface | vlan vlanid {- vlanid } ]
To delete a range of VLANs, use the following command:
no interface group vlan vlanid {- vlanid}
Interfaces
735