CLI Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell# clear dampening gigabitethernet 1/10
Clear dampening counters on TeGi 1/10 [confirm] y
Dell#
Related
Commands
• show interfaces dampening — display interface dampening information.
• dampening — configure dampening on an interface.
dampening
Configure dampening on an interface.
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-
threshold]] [max-suppress-time]]
Parameters
half-life Enter the number of seconds after which the penalty is
decreased. The penalty decreases half after the half-life
period expires. The range is from 1 to 30 seconds. The
default is 5 seconds.
reuse-threshold Enter a number as the reuse threshold, the penalty value
below which the interface state is changed to “up”. The
range is from 1 to 20000. The default is 750.
suppress-
threshold
Enter a number as the suppress threshold, the penalty value
above which the interface state is changed to “error
disabled”. The range is from 1 to 20000. The default is 2500.
max-suppress-
time
Enter the maximum number for which a route can be
suppressed. The default is four times the half-life value. The
range is from 1 to 86400. The default is 20 seconds.
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Interfaces
727