CLI Guide

Parameters
snooping Enter the keyword snooping to enable debugging of IGMP
snooping.
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface interface Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, Z9000, and Z9500.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
yield results. This command displays packets for IGMP and IGMP snooping.
ip igmp snooping enable
Enable IGMP snooping on all or a single VLAN. This command is the master on/off switch to enable IGMP
snooping.
Syntax
ip igmp snooping enable
To disable IGMP snooping, use the no ip igmp snooping enable command.
Defaults Disabled.
Command Modes
• CONFIGURATION
• INTERFACE VLAN
714
Internet Group Management Protocol (IGMP)