CLI Guide

clear ip igmp snooping groups
Clear snooping entries from the group cache table.
Syntax
clear ip igmp snooping groups [group-address interface |
interface]
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface interface Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on S-Series and Z–Series.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
yield results.
debug ip igmp snooping
Enable debugging of IGMP snooping packets on interfaces and groups.
Syntax
debug ip igmp snooping [group address | interface]
• To disable debugging of IGMP snooping, use the no debug ip igmp
snooping [group address | interface] command.
• To disable all debugging, use the undebug all command.
Internet Group Management Protocol (IGMP)
713