CLI Guide

show ip igmp groups
View the IGMP groups.
Syntax
show ip igmp [vrf vrf-name] groups [group-address [detail] |
detail | interface [group-address [detail]]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to configure this setting on that VRF.
group-address (OPTIONAL) Enter the group address in dotted decimal
format to view information on that group only.
interface (OPTIONAL) Enter the interface type and slot/port
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
detail (OPTIONAL) Enter the keyword detail to display the
IGMPv3 source information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Internet Group Management Protocol (IGMP)
707