CLI Guide

ip igmp access-group
To specify access control for packets, use this feature.
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list
command.
Parameters
access-list Enter the name of the extended ACL (16 characters
maximum).
Defaults Not configured
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on E-Series.
Usage Information The access list accepted is an extended ACL. To block IGMP reports from hosts, on
a per-interface basis based on the group address and source address that you
specify in the access list, use this feature.
ip igmp immediate-leave
Enable IGMP immediate leave.
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
700
Internet Group Management Protocol (IGMP)