CLI Guide

• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
debug ip igmp
Enable debugging of IGMP packets.
Syntax
debug ip igmp [vrf vrf-name] [group address | interface]
• To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name]
[group address | interface] command.
• To disable all debugging, use the undebug all command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to enable debugging of IGMP packets
corresponding to that VRF.
698
Internet Group Management Protocol (IGMP)