CLI Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
ipv6 dhcp snooping trust
Configure an interface as trusted for DHCP snooping.
Syntax
[no] ipv6 dhcp snooping trust
To disable dhcp snooping trusted capability on this interface, use the no ipv6
dhcp snooping trust command.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000-ON, and
Z-Series.
ip dhcp source-address-validation
Enable the IP Source Guard.
Syntax
[no] ip dhcp source-address-validation [ipmac] [vlan vlan-id]
Parameters
ipmac Enable IP+MAC Source Address Validation.
vlan vlan-id (OPTIONAL) SAV validates the source IP address along with
the source VLAN ID against the DHCP snooping binding
table.
Dynamic Host Configuration Protocol (DHCP)
625