CLI Guide

ip unknown-unicast
Enable IPv4 catch-all route.
Syntax
ip unknown-unicast
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding
table in hardware which gets added as a default configuration after the initialization
of FIB Agent module, use the no ip unknown-unicast command.
Defaults None
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of
the VRF to enable catch-all routes corresponding to that
VRF.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S–Series.
Usage Information Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route
forwarding table if it was deleted using the no ip unknown-unicast command
previously. This will be the default configuration after reload.
ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command Modes CONFIGURATION
Control Plane Policing (CoPP)
561