CLI Guide

Parameters
default Use the default CAM profile settings and set the CAM as
follows:
• L2Acl : 6
• IPV4Acl : 4
• IPV6Acl : 0
• IPV4Qos : 2
• L2Qos : 1
• L2PT : 0
• IpMacAcl : 0
• VmanQos : 0
• VmanDualQos : 0
• EcfmAcl : 0
• nlbclusteracl: 0
• FcoeAcl : 0
• iscsiOptAcl : 0
• ipv4pbr : 0
• vrfv4Acl :0
• Openflow : 0
• fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl
blocks. The range is from 1 to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP
blocks for IPv4. The range is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP
blocks for IPv6. The range is from 0 to 4.
ipv4qos number Enter the keyword ipv4qos and then the number of FP
blocks for IPv4. The range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks
for l2 qos. The range is from 1 to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks
for l2 protocol tunnelling. The range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP
blocks for IP and MAC ACL. The range is from 0 to 6.
ecfmaclnumber Enter the keyword ecfmacacl and then the number of FP
blocks for ECFM ACL. The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of
FP blocks for nlbcluster ACL. The range is from 0 to 2. By
default, the value is 0 and it supports 8 NLB arp entries
reserved for internal functionality.
550
Content Addressable Memory (CAM)