CLI Guide

Prompt Interface Type

Dell(conf-if-

nu-0)#

Null Interface then zero

Dell(conf-if-

po-0)#

Port-channel interface number The range is from 1 to 128.

Dell(conf-if-

vl-0)#

VLAN Interface then VLAN number (range 1–4094)

Dell(conf-if-

ma-1/1)#

Management Ethernet interface then slot/port information

Dell(conf-if-

tu-0)#

Tunnel interface then tunnel ID.

Dell(conf-if-

range)#

Designated interface range (used for bulk configuration).

IP ACCESS LIST Mode

To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use

the ip access-list standard command or the ip access-list extended command.

To enter IP ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter either the ip access-list standard command or the ip access-list extended

command. Include a name for the ACL. The prompt changes to include (conf-std-nacl) or (conf-

ext-nacl).

You can return to CONFIGURATION mode by using the exit command.

ISIS ADDRESS-FAMILY Mode

To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see

Intermediate System to Intermediate System (IS-IS).

To enter ISIS ADDRESS-FAMILY mode:

1. Verify that you are logged in to ROUTER ISIS mode.

2. Enter the address-family ipv6 unicast command. The prompt changes to include (conf-

router_isis-af_ipv6).

LLDP Mode

To enable and configure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information,

see Link Layer Discovery Protocol (LLDP).

To enter LLDP mode:

1. To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP

on an interface, verify that you are logged in to INTERFACE mode.

2. Enter the protocol lldp command. The prompt changes to include (conf-lldp) or (conf-if-

interface-lldp).

CLI Basics