CLI Guide

Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
peer-group-name Enter the name of the peer group for which you want to
start storing inbound routing updates.
Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address
families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command enables soft-reconfiguration for the specified BGP neighbor. BGP
stores all updates for inbound IPv6 unicast routes the neighbor receives but does
not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
show ipv6 prefix-list
Displays the specified IPv6 prefix list.
Syntax
show ipv6 prefix-list detail {prefix-list name} | summary
Parameters
detail Display a detailed description of the selected IPv6 prefix list.
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list
names.
Border Gateway Protocol
545