CLI Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series.
debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name]
ipv6 unicast soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-
address | peer-group-name] ipv6 unicast soft-reconfiguration
command.
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor on which you want to
enable soft-reconfiguration debugging.
peer-group-name Enter the name of the peer group on which you want to
enable soft-reconfiguration debugging.
ipv6 unicast Debug soft reconfiguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
Border Gateway Protocol
543