CLI Guide

NOTE: You can use this attribute to view information on
BGP peers in a peer group that correspond to either a
default or a non-default VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view information related only to
ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to view information related only to ipv4
unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to view information related only to ipv6
unicast routes.
peer-group-name (OPTIONAL) Enter the name of a peer group to view
information about that peer group only.
detail (OPTIONAL) Enter the keyword detail to view detailed
status information of the peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status
information of the peers in that peer group. The output is
the same as that found in the show ip bgp summary
command.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the
S4810 shows the ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
524
Border Gateway Protocol