CLI Guide

Usage Information Activate the VRF application on a device using the feature vrf command in

CONFIGURATION mode. The no feature vrf command is not supported on

any platform.

show feature

Verify the status of software applications, such as VRF, that are activated and running on a device.

Syntax

show feature

Command Modes

EXEC

EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.4(0.0) Introduced on the S4810, S4820T, and S6000.

Usage Information You can activate VRF application on a device by using the feature vrf command

in CONFIGURATION mode. The no feature vrf command is not supported on

any of the platforms.

Example

Dell# show feature

Feature State

------------------------------

VRF Enabled

Dell#

Command Modes

To navigate and launch various CLI modes, use specific commands. Navigation to these modes is

described in the following sections.

BGP ADDRESS-FAMILY Mode

To enable or configure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, seeBorder

Gateway Protocol IPv4 (BGPv4).

To enter BGP ADDRESS-FAMILY mode:

1. Verify that you are logged in to ROUTER BGP mode.

CLI Basics