CLI Guide

this enabling or disabling method is available. You can enable or disable the VRF application globally

across the system by using this capability.

Activate the VRF application on a device by using the feature vrf command in CONFIGURATION

mode.

NOTE: The no feature vrf command is not supported on any of the platforms.

To enable the VRF feature and cause all VRF-related commands to be available or viewable in the CLI

interface, use the following command. You must enable the VRF feature before you can configure its

related attributes.

Dell(conf)# feature vrf

Based on if the VRF feature is identified as supported in the Feature Configuration file, configuration

command feature vrf becomes available for usage. This command is stored in the running-

configuration and precedes all other VRF-related configurations.

To display the state of Dell Networking OS features:

Dell# show feature

Example of show feature output

For a particular target where VRF is enabled, the show output is similar to the following:

Feature State

------------------------------

VRF Enabled

feature vrf

Enable the VRF application on a switch. Once enabled, you cannot deactivate the VRF application.

Syntax

feature vrf

Defaults Disabled

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.5(0.0) Introduced on the Z9500.

9.4(0.0) Introduced on the S4810, S4820T, S5000, and S6000.

CLI Basics