CLI Guide

network backdoor
Specify this IGP route as the preferred route.
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor
command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information Although Dell Networking OS does not generate a route due to the backdoor
config, there is an option for injecting/sourcing a local route in the presence of
network backdoor config on a learned route.
Border Gateway Protocol
485