CLI Guide

This command automatically restarts the neighbor session for the configuration to
take effect.
Related
Commands
• bgp client-to-client reflection — enable route reflection between the route
reflector and the clients.
neighbor sender-side-loopdetect
Enables sender-side loop detection for BGP.
Syntax
neighbor {ip-address | peer-group-name} sender-side-loopdetect
To disable sender-side loop detection, use the no neighbor {ip-address |
peer-group-name} sender-side-loopdetect command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group to enable or disable all
routers with in the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults Enabled.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol
475