CLI Guide

Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
A route reflector reflects routes to the neighbors assigned to the cluster. Neighbors
in the cluster do not need not to be fully meshed. By default, when you use no
route reflector, the internal BGP (IBGP) speakers in the network must be fully
meshed.
The first time you enter this command, the router configures as a route reflector
and the specified BGP neighbors configure as clients in the route-reflector cluster.
When you remove all clients of a route reflector using the no neighbor route-
reflector-client
command, the router no longer functions as a route
reflector.
If the clients of a route reflector are fully meshed, you can configure the route
reflector to not reflect routes to specified clients by using the no bgp client-
to-client reflection command.
474
Border Gateway Protocol