CLI Guide

Version Description
7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage Information
To accept 4-byte formats before entering a 4 byte AS Number, configure your
system. If the number parameter is the same as the AS number used in the router
bgp command, the remote AS entry in the neighbor is considered an internal BGP
peer entry.
This command creates a peer and the newly created peer is disabled (Shutdown).
This command automatically restarts the neighbor session for the configuration to
take effect.
Related
Commands
• router bgp — enter ROUTER BGP mode and configures routes in an AS.
• bgp four-octet-as-support — enable 4-byte support for the BGP process.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-
name} remove-private-as command.
Parameters
ip-address Enter the IP address of the neighbor to remove the private
AS numbers.
peer-group-name Enter the name of the peer group to remove the private AS
numbers.
Defaults Disabled (that is, private AS number are not removed).
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Border Gateway Protocol
471