CLI Guide

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable soft-reconfiguration debugging on that
VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor in
dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group..
Defaults Disabled
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage Information
This command turns on BGP soft-reconfiguration inbound debugging. If no
neighbor is specified, debug turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] updates [in | out | prefix-list prefix-list-
name]
Border Gateway Protocol
447