CLI Guide

Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced IPv6 MGBP support for the E-Series.
debug ip bgp events
Display information on local BGP state changes and other BGP events.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] events [in | out]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D
| X:X:X:X::X | peer-group peer-group-name] events [in | out]
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to display BGP state changes corresponding to
that VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only events on
inbound BGP messages.
Border Gateway Protocol
443