CLI Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
If you enter the bgp dampening command, the default values for half-life,
reuse, suppress, and max-suppress-time are applied. The parameters are
position-dependent; therefore, if you configure one parameter, configure the
parameters in the order they appear in the CLI.
Route refresh is sent when you enable BGP dampening.
Related
Commands
• show ip bgp dampened-paths — view the BGP paths.
bgp default local-preference
Change the default local preference value for routes exchanged between internal BGP peers.
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Parameters
value Enter a number to assign to routes as the degree of
preference for those routes. When routes are compared, the
higher the degree of preference or local preference value,
the more the route is preferred. The range is from 0 to
4294967295. The default is 100.
Defaults 100
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
Border Gateway Protocol
423