CLI Guide

NOTE: Use this attribute to start a BGP instance
corresponding to either a specific address family in a
default VRF or an IPv4 address family in a non-default
VRF.
ipv6 unicast Enter the keyword ipv6 followed by the keyword unicast
to enable BGPv6 mode.
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of
the VRF to install the IPv6 route in that VRF.
NOTE: It will not be possible to enable VRF mode for
IPv6 unicast without configuring the corresponding IPv4
unicast mode for the same VRF. While deletion,
whenever the IPv4 VRF mode is deleted for the VRF, it
will automatically delete the IPv6 VRF configurations as
well.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for IPv6 VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.5.1.0 Introduced
Border Gateway Protocol
407