CLI Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.3.(0.0) Introduced on S6000.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Introduced on Z9000, S4810, and S4820T.
8.2.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
ipv6 ospf bfd all-neighbors
Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session
parameters.
Syntax
ipv6 ospf bfd all-neighbors [disable | [interval interval
min_rx min_rx multiplier value role {active | passive}]]
To disable all BFD sessions on an OSPFv3 interface implicitly, use the no ipv6
ospf bfd all-neighbors disable command in interface mode..
Parameters
disable (OPTIONAL) Enter the keyword disable to disable BFD on
this interface.
interval
milliseconds
(OPTIONAL) Enter the keyword interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is 200.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at
which the local system receives control packets from the
remote system. The range is from 50 to 1000. The default is
200.
multiplier value Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active — active system initiates the BFD session. Both
systems can be active for the same session.
• Passive — passive system does not initiate a session. It
only responds to a request for session initialization from
the active system.
398
Bidirectional Forwarding Detection (BFD)